Instructions On Applying Vinyl

Take a look at our instructions guide below so your decal will adhere correctly.

Instructions on applying vinyl.

Apply masking tape on the area then remove. It is simple to the point and will clearly direct your buyer on how to correctly and successfully apply a vinyl decal. Peel away the vinyl liner at a 45 degree angle. The bottom layer is the backing paper.

Make sure your project surface is clean dry. Do not use a glass cleaner because it will leave a residue behind that will prevent the sticker from adhering well. Then take a heat gun or hairdryer and warm the surface and even some light heat on the sticker can t hurt don t put too much it can damage it. If the vinyl does not separate from the liner simply burnish the transfer tape onto the vinyl and peel away again.

Clean the area thoroughly with rubbing alcohol or soap and water. When looking to start selling items with your silhouette or cricut adhesive vinyl decals are. Spray car generously with the application spray provided or use a mixture of soapy water in a spray bottle. Maneuver the decal into.

Begin by ensuring the surface has been cleaned and prepared properly. Mark this location on the surface using your grease pencil. While it is fairly simple it is important to follow some guidelines when you are applying. Step 2 rub a squeegee or credit card firmly across the sticker through the clear transfer tape to prepare it for application.

Spray the back of the vinyl as you peel it back. Do this a few times to tack up the surface plus it removes small pieces of dust and imperfections. Using a measuring tape measure the total distance of the surface the vinyl is to be applied to. Step 4 apply decal to cleaned area pressing firmly using squeegee or credit card.

It s important to begin by cleaning the area. This decal application instruction printable is the perfect item to add to your adhesive vinyl decal orders. Step 3 peel the paper backing away from the decal very slowly. When you receive your decal in the mail lay it flat and firmly wipe a credit card or application squeegee across the top of the transfer tape.

The top layer is paper transfer tape which is used to apply the decal. Step 1 clean the application area with alcohol or soap water. Divide the distance by 2 to determine the center point. The second layer is the vinyl film which is the decal itself.

Carefully place the transfer tape with vinyl images onto your surface as you would like them to appear. Place the decal on the car ensuring no part of the decal touches a try spot.